QUOTE : In 1983 Donald Rahn of Rahn Granite Surface Plate Co. told me that diamond drills, rotating at nine hundred revolutions per minute, penetrate granite at the rate of one inch in five minutes. In 1996, Eric Leither of Tru-Stone Corp. told me that these parameters have not changed since then. The feedrate of modern drills, therefore, calculates to be .0002 inch per revolution, indicating that the ancient Egyptians drilled into granite with a feedrate that was five hundred times greater or deeper per revolution of the drill than modern drills! The other characteristics of the artifacts also pose a problem for modern drills. Somehow the Egyptians made a tapered hole with a spiral groove that was cut deeper through the harder constituent of the granite. If conventional machining methods cannot answer just one of these questions, how do we answer all three?